FiberX FX-P220 User Manual

FiberX DisplayPort Fiber Extender Pigtail User Guide
FX-P220
Thank you for purchasing FX-P220
The optical DisplayPort pigtail extender with DPCP support extends Dis-
playPort signals up to 300m using single strand multi-mode optic fiber. It
supports display resolutions up to 2560x1600 (WQXGA).
Package Contents
Please make sure all of the following items are included in the package:
1 FX-P220 Transmitter & Receiver
2 +5V DC Power supply x 1pcs
3 User Guide
If any of the above items are missing, please contact your supplier for support.
Note: Package content may differ if you have placed a special order or placed order from anywhere other than
PureLink GmbH. PureLink GmbH reserves the right to make changes without further notice to a product de-
scribed herein to improve reliability, design, packaging or function.
Installation
Installation Steps:
1. Connect the Transmitter module to the DisplayPort source device.
2. Connect the Receiver module to the display.
3. Connect a single strand multi-mode SC terminated optic fiber (50/125µm)
from the Transmitter to the Receiver module.
4. Connect the included +5V DC power supply into Receiver module.
5. A blue indicator LED will light up after all connections are completed.
Note: The Transmitter module does not need to be externally powered unless the source device does not
supply enough power through the DVI connector.
1
K n o w - H o w . Q u a l i t y . D e s i g n .
PureLink GmbH | Von-Liebig-Straße 10 | 48432 Rheine | Germany | Tel.: 0049 (0)5971-800 299-0 | E-mail: info@purelink.de | Internet: www.purelink.de
LED indicator
SC type optical port
DC +5V
Power jack
I n n o v a t i o n G e r m a n E n t e r p r i s e s .
1