Software Installation; System Setup Using Linux Commands; System Setup Using The Vca Manager - Nvidia Quadro VCA Installation Manual

Software installation

Software installation
.

System setup using Linux commands

When booting and the Quadro VCA is connected on interface
will be used by default.
A unique hostname is preset.
To change the default settings (hostname, IP address, default route), log in either on the
console or per ssh as user
sudo system-config-network
This will modify the following system files:
/etc/sysconfig/network-scripts/ifcfg-eth<N>
/etc/sysconfig/network
/etc/hosts
Note: Contact your network system administrator to add the hostname of the Quadro
VCA to DNS.
.

System setup using the VCA Manager

Network settings can be changed from the VCA Manager interface if you are not familiar
with Linux.
1 Connect a second machine (for example, your laptop) to the configuration port
2 Set this second machine to any IP address from the 192.168.124.0 network.
3 Connect to
http://
NVIDIA Quadro Visual Computing Appliance — Installation Guide
and run:
iray
VCA-IP-address.
. System setup using the VCA Manager
to local network DHCP
eth3
eth2
© NVIDIA Corporation
.