Download Print this page
Hide thumbs Also See for SPEEDCUT 50:

Advertisement

Quick Links

SPEEDCUT
ERROR
i
When illuminated refer to error code on display and resolve.
POWER
i
When illuminated the power source is on.
O.T
When illuminated machine is over temperature, do not turn
i
o and allow to perform cooling cycle.
CONTROL DIAL FUNCTIONS
i
Amperage control/Press for 2 seconds for air test press to stop.
DIGITAL DISPLAY
50
i
Amperage setting , real time amperage display, error codes.
OPERATORS MANUAL
Read operators manual before use - download from
i
swswelding.com.au
DISPLAY CODES
i
ERROR! Under Pressure
Air pressure is below 60 PSI.
i
ERROR! Missing Shield Cup
Shield cup is damaged or missing; torch lead is not connected
securely (Inspect & replace or install).
i
ERROR! Missing Electrode or Nozzle
Electrode or nozzle is excessively worn or missing (Inspect & replace or install).
i
ERROR! Over Temperature
Machine has reached duty cycle limit allow to cool.
ERROR! Over Voltage
Incorrect input voltage supplied damage may have been caused.
Contact support if persists.
50
FOR CONSUMABLES & SUPPORT GO TO WWW.SWSWELDING.COM.AU
QUICK REFERENCE GUIDE
ON/OFF SWITCH (ON BACK OF MACHINE)
AIR INLET FITTING (ON BACK OF MACHINE)
1 Phase 240V +/- 15%
(8.5kVA at 0.8 PF)
CAUTION! If the mains power supply/generator
is not su icient, the machine will not maintain
a cutting arc, and it may damage the
power source.
Move to di erent mains power outlet, eliminate
i
or reduce extension lead, use higher output
generator, reduce cutting amperage.
MIN 100 L/m - 75 psi
CAUTION! Ensure compressor/gas regulator
pressure is set between 75 - 100 PSI.
Exceeding 100 PSI can damage the internal
regulator.
CAUTION! Only use clean, dry air for optimum
cutting performance and to prevent premature
servicing of internal regulator filter.
NEGATIVE CENTRAL TORCH LEAD PORT
POSITIVE GROUND CLAMP CABLE PORT
MIN GENERATOR

Advertisement

loading
Need help?

Need help?

Do you have a question about the SPEEDCUT 50 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SWS SPEEDCUT 50

  • Page 1 SPEEDCUT ™ QUICK REFERENCE GUIDE ON/OFF SWITCH (ON BACK OF MACHINE) ERROR AIR INLET FITTING (ON BACK OF MACHINE) When illuminated refer to error code on display and resolve. POWER 1 Phase 240V +/- 15% When illuminated the power source is on. MIN GENERATOR (8.5kVA at 0.8 PF) CAUTION! If the mains power supply/generator...
  • Page 2 ™ START UP PROCEDURE WARNING! The pilot arc can cause serious burns - Never Plug machine into a suitable mains power supply or generator and engage trigger switch when torch tip is directed towards turn on using the ON/OFF switch (Located on the back of the machine). the eyes, face or body of yourself or others.