Warning: Safety Precautions; Before Using - Remington r300 Operating Instructions Manual

The following pages contain detailed warnings, cautions, and
rules of safe operation. Read carefully and become familiar
before operating to avoid serious injury. We expressly disclaim
any liability for any injury to persons or damage to property
which result from your failure to take the precautions contained
in this manual.
WarnInG: This tool is designed only for use by qualified
operators. Qualification is obtained through a thorough under-
standing of the Safety Precautions and operating instructions
as defined in this operating manual. nOtE: The labor regula-
tions of many states require that the operator of this tool on
a job site be thoroughly trained and certified for competence
prior to operating this tool. For certification procedures, call:
DESA Power Tools™ Technical Services Department, 1-800-
858-8501 (English only) or visit www.desatech.com.

BEFOrE USInG

1. aLWaYS handle the tool
as if it were loaded. Before
starting work, check that
the tool is unloaded and
the muzzle is clear. nEVEr
load a tool unless it is going
to be used.
2. aLWaYS inspect to make sure the tool is working properly.
If the tool does not work properly, remove from service and
tag DEFECtIVE. DO nOt use the tool again until it has
been properly repaired.
3. Operators and bystanders must aLWaYS wear goggles
and ear protection which meet or exceed the accepted
standards for adequate protection in your country. In the
USA, refer to ANSI standards. In Canada, refer to CSA
standards.
119586
Warning: Safety
precautions
S F
489.004
?
3
?
S F
S F