Remington r300 Operating Instructions Manual page 21

Power load listings are recommendations only. If you are in
doubt, try a test fastening using the next lightest power load.
Power fasteners and power loads are available in blister packs
of 5 and cartons of 100.
ImpOrtant
• Recommended for use with Remington
power fasteners.
• If power fastener goes below the top surface of the board,
use penetrating control disc (see illustration below) or wash-
ered SPW-type power fasteners.
• Operators and bystanders must aLWaYS wear goggles and
ear protection which meet or exceed the accepted standards
for adequate protection in your country. In the USA, refer to
ANSI standards. In Canada, refer to CSA standards.
* Use power fastener with penetration control disc, part
number 015549.
This tool is designed to use . caliber neck-down crimped
loads, power levels 1 (gray) through 4 (yellow).
5/8"
Neck-Down Crimped
Power Load
CaUtIOn: Do not use any load other
than the .22 caliber neck-down crimped load.
Other types of loads will cause load-ejection
problems.
. CALIBER Type A, neck-down crimp loads for powder
actuated tools
Stock
number number
AC1
AC
AC3
AC4
119586
application Chart
ImpOrtant
Load
Level
1

3
4
Straight Wadded
Power Load
Load
Strength
light
medium
heavy
extra heavy brass
1
power loads and
®
Color Code
Case
Body Head
brass Gray
brass Brown
brass Green
Yellow