Swing-N-Slide NE 4569L Assembly Instructions Manual

Advertisement

Quick Links

No. of Children: Up to 2
Min. Use Zone: 18 '-6'' Dia.
Set Dim. 6'-6'' Dia.
Est. Building Time: 2 hrs.
WARNING:
!
Assembly by an adult.
Other benefits include information on product warranties, assembly plan updates, joining our
mailing list for new products and promotions, receiving our newsletter, and providing feedback on
Swing•N•Slide • 1212 Barberry Drive • Janesville, Wisconsin 53545
To register your product visit:
http://www.swing-n-slide.com
products.
Visit our web site at: www.swing-n-slide.com or call us at
1-800-888-1232
NE 4569L
6'-6'' Diameter
Set Dim.
18'-6'' Diameter
Min. Use Zone

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NE 4569L and is the answer not in the manual?

Questions and answers

Summary of Contents for Swing-N-Slide NE 4569L

  • Page 1 Other benefits include information on product warranties, assembly plan updates, joining our mailing list for new products and promotions, receiving our newsletter, and providing feedback on products. Swing•N•Slide • 1212 Barberry Drive • Janesville, Wisconsin 53545 Visit our web site at: www.swing-n-slide.com or call us at 1-800-888-1232...
  • Page 2 When the equipment is taken out of service, it must be disassembled and disposed of in such a way that no unreasonable hazards will exist at the time the set is discarded. Important! Additional Safety Instructions for all Swing-N-Slide Playground Equipment. Save this instruction sheet in the event the manufacturer needs to be contacted.
  • Page 3 Swing-N-Slide® will repair, or at its discretion, replace any part within the stated warranty period which is defective in workmanship or materials. This decision is subject to verification of the defect upon delivery of the defective part to Swing-N-Slide® at 1212 Barberry Drive, Janesville, Wisconsin, 53545. Any part(s) returned to Swing-N- Slide®...
  • Page 4 ssembly Instructions TOOLS ND H RDW RE...
  • Page 5 ssembly Instructions Fig. 1 Fig. 2 Fig. 3...
  • Page 6 ssembly Instructions Fig. 4 Fig. 5 Fig. 6 Fig. 7 Note: Snug Bolt Only, DO NOT Overtighten.
  • Page 7 ssembly Instructions Fig. 8 Optional Seesaw Anchoring Method: 1. Place the Seesaw in the desired position. Mark a 12'' x 12'' square around each of the Seesaw feet and, using these guidelines, dig holes 14'' deep. 2. Fill each hole with a minimum of 12'' of concrete. Do not exceed the ground level. 3.
  • Page 8 Questions???... Call our Customer Service Department at 1-800-888-1232 © PlayCore Inc. 2011 Printed In USA LA 6186...

Table of Contents