Orientation To The Quickart 2000 - Dane Technologies QuicKART 2000 Owner's Manual

ORIENTATION TO THE Q
MANUAL MODE: Manual Mode is defined as operating the QuicKART while walking
behind the QuicKART 2000.
controlled by turning the twist grip throttle. Direction is controlled by touching the touch
pad switch located on the control panel. When the switch is pressed, the direction
changes between forward and reverse as indicated by the direction light.
REMOTE MODE: (See diagram on page 34.) Remote Mode is defined as operating the
QuicKART with the remote control while standing or walking alongside the lead cart of the
cart chain coupled to the QuicKART 2000. Steering is controlled by guiding the lead cart
in the desired direction. Forward speed, brakes and horn are operated with the hand held
radio remote control. While in remote mode, the QuicKART will only move forward.
CONTROL PANEL: (See diagram on page 34.) At the top of the Control Panel are 5
lights which show the percent of remaining battery capacity (Battery Charge Level).
When the batteries are fully charged the light at the "100" mark will be lighted. As the
QuicKART is used throughout the day, the lights will slowly change from 100 to 80, 60,
and 40 until the light for 20 is lighted. The charging level is most accurately shown when
the QuicKART is pushing carts. When the 20% capacity light starts to flash on and off, it
means there are approximately 4 minutes of remaining power before the QuicKART
automatically shuts down. If the QuicKART does shut down, turn the key off for a few
minutes, then on again. This may allow time to reach the charging station. Recharge the
batteries for at least 8 to 10 hours or until fully recharged.
The control panel also includes a series of 4 lights and panel button switches with the
following functions:
The light labeled "MANUAL" is for manual operation and "RADIO" is for remote
operation. The push button switch, just below these two lights, will toggle between
manual and remote control.
operation and forward whenever it is turned on. It cannot be moved from manual
to remote operation when the QuicKART is moving, only when it is stopped.
The light labeled "FORWARD" is for Forward-Direction operation and "REVERSE"
is for Reverse-Direction operation. The push button switch, just below these two
lights, will toggle between forward and reverse QuicKART direction.
QuicKART will always be set to forward operation whenever it is turned on. The
switch will not change the operational direction until the QuicKART is stopped. For
safety, the remote mode allows operation only in the forward direction.
Pressing the "HORN" button will sound the horn loudly as long as it is pressed.
Dane Technologies, Inc.
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com
UIC
Direction is controlled by the handle bar.
The QuicKART will automatically set to manual
QuicKART 2000
KART 2000
Owner's Manual
970-026 rev 3-1-06
Speed is
The
32