Troubleshooting - Remington BV12199A Owner's Manual

12 |
6

troubleshooting

WARNING: Unplug blower/vac from power source before servicing. Severe
injury or death could occur from fire, electrical shock, or rotating impeller.
Note: For additional help, visit our
te c h ni c al s er v ic e we b s i te a t
www.desatech.com.
OBSERVED FAULT
Motor does not run when you turn on/off
switch low or high
Motor runs, but vacuum will not pick
up debris
Blower/vac vibrates excessively and/or
makes abnormal noises
Technical Service
You may have further questions about
assembling, operating, or maintaining this
blower/vac. If so, you can visit our Technical
Service web site at www.desatech.com or
contact our Technical Service Department
at 1-800-858-8501 (English only). You
may also write to:
DESA Specialty Products™
ATTN: Technical Service Specialty
Products
P.O. Box 90004
Bowling Green, KY 42102-9004
POSSIBLE CAUSE
1. Bottom inlet cover or vacuum tube
adapter not locked into place
2. Extension cord connection is loose
1. Clogged vacuum tube or impeller
2. Vacuum bag full
Clogged vacuum tube or impeller
When contacting DESA Specialty Prod-
ucts™, have ready
• Your Name
• Your Address
• Your Phone Number
• Model Number of Product
• Date of Purchase (include copy of receipt
for written requests)
REMEDY
1. Check inlet cover or vacuum tube
adapter for proper installation (see
blower/vac assembly, page 4)
2. Check cord connection at electrical
outlet and at rear of blower/vac
1. Follow steps under Removing
Clogged Debris from the Impeller,
page 10
2. Empty vacuum bag (see Emptying
the Vacuum Bag, page 10
Follow steps under Removing Clogged
Debris from the Impeller, page 10
118034