Altinex TNP461 User Manual

Tilt 'N Plug
Welcome!
We greatly appreciate your purchase of the TNP461. We are sure
you will find it reliable and simple to use. Superior performance
for the right price, backed by solid technical and customer support
is what Altinex has to offer.
We are committed to providing our customers with Signal
®
Management Solutions to the most demanding audiovisual
installations at competitive pricing and we welcome you to join the
ranks of our many satisfied customers throughout the world.

1. Precautions and Safety Warnings

Please read this manual carefully before using your TNP461.
Keep this manual handy for future reference. These safety
instructions are to ensure the long life of your TNP461 and
prevent fire and shock hazards. Please read them carefully and
heed all warnings.
1.1 General
•
Qualified Altinex service personnel or their authorized
representatives must perform all service.
1.2 Installation Precautions
•
Place the Tilt 'N Plug Jr. in a dry area away from dust.
•
Handle the TNP Jr. carefully. Dropping or jarring can
damage the bezel.

2. Installation Procedures

Step 1. Download and read the entire online manual to become familiar with the TNP461 and for detailed installation.
Step 2. Cut an opening into the table's surface. Refer to the Altinex website at
Note: The table can be 2.25" or less in thickness. Always confirm dimensions
before cutting to insure that specifications have not changed.
Step 3. Insert the TNP461 into the cutout. Under the table, place the support brackets
into the grooves on the side of the unit at the desired height and secure using
the knurled thumb screws. Tighten wing nuts to set screws in place. See
Diagram 3 of online manual for details. To lower the unit, push on the top cover
until it locks into place.
Step 4. Secure cables to the underside of the table using the hardware provided. Secure
the power cord to the table separate from the signal cables. Leave enough slack
in the power cord service loop to allow for easy opening and closing, but not too
much as to cause excess drooping of the service loop. Adjust loop for best
opening and closing of unit.
Step 5. Connect your cables to their corresponding input connectors on the bottom of the unit. Raise the unit into
position, push down on the front of the top cover; the latching mechanism will then release, allowing the
spring to raise it into position.
Step 6. To lower the unit, push on the top of the Tilt 'N Plug Jr. until it locks into place.

3. Limited Warranty/Return policies

Please see the Altinex website at
400-0623-001
®
Jr. Interconnect Boxes
http://www.altinex.com
•
To prevent fire or shock, do not expose this unit to water
or moisture. Do not place in direct sunlight, near heaters
or heat-radiating appliances, or near any liquid. Exposure
to direct sunlight, smoke, or steam can harm internal
components.
•
Never place fingers inside the opening on either side of
the unit. This could cause injury due to sharp edges.
•
Do not place heavy objects on top of the TNP Jr. Do not
use excessive force to push down on the top of the unit.
•
Disconnect the power cord to turn off the main power.
This supplies power to the power socket on the pop up
panel. The power outlet should be installed near the
equipment and should be easily accessible.
•
We recommend using outlets with a Ground Fault Circuit
Interrupter (GFCI) for maximum protection.
•
Install all cables according to the instructions found
herein. Do not force or pull cables or power cords.
1.3 Cleaning
•
Surfaces should be cleaned with a dry cloth. Never use
strong detergents or solvents such as alcohol or thinner.
Do not use a wet cloth or water to clean the unit.
www.altinex.com
for details on warranty and return policies.
1
User's Guide
for table cutout requirements.