Advertisement
KNOW YOUR CLASSIC JUG KETTLE
LID SEAL
SPOUT
WATER FILTER
VIEWING WINDOW
MAX MARK INDICATOR
POWER NEON
(RED)
POWER BASE
CORD TIDY
All illustrations are for representation only, your model may vary from illustrations shown. In the interest of improving products, Dualit Ltd.
reserves the right to change the product specification without prior notice.
SETTING UP
1
2
POSITION
CORD TIDY
Place the kettle as close to the wall
Use the shortest cord possible.
socket as possible. When in use ensure
Wrap excess cord round the
the kettle is not placed under kitchen
cord tidy on the base of
cabinets. DO NOT STORE OR
the kettle.
USE YOUR KETTLE IN AN
APPLIANCE GARAGE OR
UNDER CUPBOARDS.
FILLING YOUR KETTLE
WARNING: IF THE KETTLE HAS JUST BOILED, IT WILL BE FULL OF STEAM, WHICH WILL ESCAPE AS SOON AS
THE LID IS OPENED. THE LID WILL BE HOT. USE THE LID RING TO OPEN AND CLOSE THE LID.
OPEN LID
1
2
Ensure the kettle is unplugged. Remove the
Tip: If the lid is too tight, try pushing in the
kettle from the power base. Gently pull the lid
pips on the inside of the lid with a spoon
ring up and back to open the lid.
handle. Pushing the lid pips back out will give
a tighter fit. WARNING: IF THE LID IS
TOO LOOSE, RISK OF SCALDING.
3
4
INCLINED PLANE
Do not operate on an inclined
Do not operate in a tray.
plane.
LID TIGHTNESS
FILLING
3
Fill the kettle through the lid opening. Use at
least one cup of water (250ml). The water level
must stay below the 'max' mark. Save energy,
only boil what you require. Keep kettle upright
and level at all times when filling. Do not tilt
kettle backwards. DO NOT OVERFILL OR
FILL THROUGH THE SPOUT.
Push the lid down using the lid ring to close.
BOILING WATER
HINGED LID
1
TURN ON
LID RING
LID PIP (3x)
SURE GRIP HANDLE
ON/OFF SWITCH
Plug the kettle into the power socket. Press the
'On/Off' switch down. The power neon will
illuminate and the kettle will start to heat up.
POWER CORD
If the kettle is accidentally switched on with no
water inside, the boil-dry device will switch off the
heating element to prevent damage to the kettle.
CLEANING & CARE
1
THE BODY
NOT IN A TRAY
Unplug and let the kettle cool down
completely before cleaning. Remove the
kettle from the power base.
Wipe the outside and inside surfaces of the
kettle with a damp cloth.
KETTLE REPAIR
Core components of your kettle are replaceable!
The Classic Kettle has been built to last, but should you experience any fault with your kettle, please contact Dualit for advice. The
Classic Kettle is repairable and fitted with a patented, repairable element. Simply contact our helpline on 01293 652 500 or visit www.
dualit.com/support for repair or servicing advice.
All servicing must be carried out by Dualit or authorised repair agent.
For your own protection only use original Dualit spares in your kettle. Fitting of non Dualit parts will invalidate the guarantee.
2
TURN OFF
The kettle will automatically turn off after the
water has boiled.
To turn off before the water has boiled lift
the 'On/Off' switch up.
Always unplug the kettle after each use.
2
WATER FILTER
Unplug and let the kettle cool. Open the lid.
Hold the top of the filter, pull up and out of
the kettle. Rinse under a tap while carefully
brushing it with a soft brush.
Rinse the kettle out with fresh water.
DO NOT OPERATE KETTLE
UNLESS THE WATER FILTER IS
CORRECTLY IN POSITION.
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose of this product in the usual household garbage at the end of its life cycle. Please hand
it over to a collection point for the recycling of electrical and electronic appliances. The symbol on the
product, the instruction of use or the packaging will inform you about the methods of disposal. The
materials are recyclable as mentioned on its marking. By recycling, material recycling or other forms of
re-utilization of old appliances you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorised disposal location.
3
POURING
Remove kettle from the power base.
To avoid the risk of splashing, once the kettle
has boiled wait 10 seconds then pour slowly.
Do not over-tilt the kettle.
3
DESCALE REGULARLY
Use descaling products suitable for kitchen
appliances, these are readily available online
or from most supermarkets or department
stores. Use as per instructions on the packet.
Follow these few simple steps to minimise
scale build up in your kettle: Empty the kettle
after each use; do not allow water to stand in
the kettle overnight. Use filtered water instead
of tap water. Descale the kettle regularly, at
least once a month. If you live in a hard water
area you may need to descale more often.
When descaling has finished, empty the
kettle and rinse it out a minimum of 3 times
with fresh water, then refill with fresh water,
boil, then discard boiled water. FAILURE
TO DO SO CAN CAUSE INJURY.
DO NOT BOIL KETTLE WITH
DESCALING SOLUTION IN IT.
Advertisement
