Install The Batteries In The Remote Control - Harman Kardon AVR700 Service Manual

AVR700
Audio recorders
Connect an analog audio recorder's inputs to the AVR's analog audio Tape Out connectors.
You can record any analog audio input signal except for the Tape 1 input.
AVR Analog Audio
Recorder Connectors
Stereo Audio Cable
(not supplied)
Video recorders
Connect an analog video recorder's video input connector to the AVR's Video 1 Out
Composite Video connector, and its audio input connectors to the AVR's Video 1 Out
Analog Audio connectors. You can record the Video 2 or Video 3 composite video input
signals.
AVR Analog
Audio Connectors
Analog Audio/Video
Cable (not supplied)
Connect the Radio Antennas
the best reception, extend the FM antenna as far as possible.
antenna wires to the AVR's AM and Gnd connectors. Rotate the antenna as necessary
to minimize background noise.
AVR Antenna
Connectors
FM Antenna (supplied)
AM Antenna
(supplied)
To Stereo Analog
Record Inputs
Analog Recording Device
AVR Composite
Video Connectors
To Analog Audio/
Video Record Inputs
Analog Video
Recording Device
Radio Antenna connector. For
Bend and fold base
11
Connect to AC Power
Connect the AC power cord to the AVR's AC Input connector and then to a working AC
power outlet.
AVR AC
Input Connector

Install the Batteries in the Remote Control

Remove the remote control's battery cover, insert the three supplied AAA batteries as
shown in the illustration, and replace the battery cover.
NOTE: Remove the protective plastic from the AVR's front panel to keep it from reducing
the remote control's effectiveness.
harman/kardon
AC Power
Outlet
Power Cord
(supplied)