Lennox iComfort E30 User Manual page 6

Table 3. Home Screen and System Status Icons
Icon Screen Text
Changing set
point range
Turning feels
like on
Schedule hold until next period
Coasting to
Perfect Temp
Coasting to
Perfect Temp
F. Away - When away icon is touched, the system will automatically use energy
saving settings which is heat-to 62 and cool-to 85 in Fahrenheit or heat-to 16.5
and cool-to 29.5 in Celsius). Temperatures can be adjusted by pressing on the
available temperature setting (i.e., heat-to or cool-to). To exit away, press the
cancel icon. Note that when manually selecting Away from the home screen,
the Smart Away feature (if enabled under settings) will be temporally disabled
until Away is canceled. See page 10 for additional information.
G. Pressing on the heat-to area will allow the temperature setting to be changed.
H. Pressing on the cool-to area will allow the temperature setting to be changed.
NOTE: If the system is running on a schedule, any adjustment will display schedule
will hold until next period or select duration of hold. Touch hold or duration
to select the desired time. The hold period can be canceled by pressing the
cancel icon on the right side of the Home Screen.
I. Select Mode: Touch modes/schedules to select the system mode of operation,
run a schedule, fan mode operation and turn the system off. To exit this screen,
press the home icon.
"Figure 4. Select Mode" shows the various modes of operation that may be
available. To select a mode for the system or a specific zone, press the desired
operation. The gray shaded area indicates the item has been selected.
Purpose
Temperature is being adjusted.
Indicating the system is transitioning to "feels like"
mode.
Coasting allows the current temperature to reach the
desired single set-point without the system doing any
work. The red arrow indicates the temperature is less
than the desired set point. The blue arrow indicates is
greater than the desired set point.
heat only
cool only
Figure 4. Select Mode
NOTE: Options are dependent on system configuration. For example, emerg heat
- emergency heat) will be auxiliary heat for heat pump systems only.
• Off: System is off. In addition, if system is off, Alexa will be unable to adjust the
temperature.
• Cool Only: System will run only in cool mode.
• Heat Only: System will run only in heat mode.
• Heat / Cool: This is the auto-changeover mode. System will heat or cool your
home at the temperature set point you desire.
• Emergency Heat: Selecting this setting will run the air handler's electric heat or
furnace instead of the heat pump for heating. This selection is only available with
systems using a heat pump.
• Fan Operations: There are three fan modes of operation, which are auto, on and
circulate. Pressing on the fan icon will allow selection of the desired fan mode.
Table 4. Fan Operations
Fan Icon Fan Mode
ON
AUTO
CIRC
6
heat / cool
emerg heat
select mode
schedules
Description
Fan is NOT following the schedule and runs continuously
until it is changed from the selected mode.
Fan will follow the fan setting in the selected schedule.
Fan is following schedule and cycles during periods of
equipment inactivity. Circulate run time is dependent on
user settings.
auto