Discs Maintenance - Innovative Technology ITCDS-5000 Manual

3. Press the PROGRAM button on the remote
control to add the track into the program list.
4. Repeat steps 2 and 3 to till you accomplish the
programming.
You can program up to 20 tracks.
TO START THE PROGRAM PLAY
Press PLAY/PAUSE button.
TO PAUSE OR STOP A PROGRAM PLAY
Press PLAY/PAUSE or STOP button.
TO REPLAY A PROGRAM
Press PLAY/PAUSE button.
TO REVIEW THE CONTENT OF A PROGRAM
Press STOP button then keep pressing the
PROGRAM button to review the programmed
tracks.
TO CLEAR THE PRORAM
Press STOP button twice.
Open and close the CD door to clear the program
play.
After play, remove the CD.

DISCS MAINTENANCE

Depending on the quality of the disc and the condition of the recording, some CD-R/CD-RW disc
may not be playable.
1. Always place the compact disc in the disc tray with the label facing upward. (Compact discs
can be played only on one side).
2. To move a disc from its storage case, press down on the center of the case and lift the disc out,
holding it carefully by the edges.
3. If the disc becomes dirty, wipe the surface from the center hole outward towards the outer
edge with a soft, dry cloth.
4. Never use such chemicals as record spray, antistatic sprays or fluid, benzine or thinner to
clean the discs. Such chemicals will do irreparable damage to the disc's plastic surface.
5. Discs should be returned to their cases after use to avoid serious scratches that could cause
1