Get Started; Connecting External Speakers; Preliminary; Listening To The Radio - Innovative Technology ITCDS-5000 Manual

GET STARTED

CONNECTING EXTERNAL SPEAKERS

The speaker input sockets locate at the back of the main unit.
Unwrap the speaker wire from the left speaker and plug it into the left (L) speaker socket on the
main unit.
Unwrap the speaker wire from the right speaker and plug it into the right (R) speaker socket on
the main unit.
Make sure the speaker cables will not run in areas where they could cause danger.

PRELIMINARY

Before connecting power to your audio system, the protective packing should be removed from
the CD compartment.
To remove the protective packing:
Press the EJECT/ENTER button at the front corner to open the CD door.
Remove the protective packing from the CD compartment.
Close the CD door by pressing the EJECT/ENTER button to latch it shut.
FM ANTENNA
Unwrap the FM antenna and extend it fully. You may need to adjust the position of the antenna
to get optimum reception.
CONNECTING THE POWER
Check that the mains voltage in the rating plate on the back of the main unit is the same as the
voltage in your area.
Plug the electric plug into the wall socket. Now the audio system is ready for use.
STANDBY CONTROL
To turn the main unit on:
Press the POWER button. The unit will turn on.
To turn the power off:
Press the POWER button to turn the unit off.
NOTE: When leaving the unit unattended for long period (such as holidays), please disconnect the
power plug from the mains supply.

LISTENING TO THE RADIO

1. Press the FUNCTION BUTTON to Switch to FM RADIO function and the display will show "FM".
2. Tune to a desired radio station. The frequency is indicated on the display.
MANUAL TUNING: Press the TUNING + or TUNING button briefly and the frequency will be
tuning up or down at a step.
AUTO SEARCHING: Press the TUNING + or TUNING - button for more than 2 seconds, radio
frequency will start to change on the display. Once a station is found, the radio will stop searching
and start to broadcast immediately.
3. Re-position the antenna if necessary.
1