Download Print this page

Handy Man Nail Finder Operating Manual page 4

Hand held metal detector

Hide thumbs

page of 4

/ 4
Bookmarks

Enlarged version

First Time Operation

To Operate the Detector

1) Install the Battery

a. Use a 9-volt ALKALINE battery only (battery not included)

b. Install battery with correct polarity

(align "+" on detector housing with "+" on battery)

c. The battery cover opens and closes with a coin or screwdriver

2) Set the On switch to "ON"

"ON" is the middle position

3) Set the Audio/Vibrate Switch to "AUDIO"

4) Sweep the Detector over the target area.

Detector must be IN MOTION to detect metal

First Time Operation

To Operate the Detector

1) Install the Battery

a. Use a 9-volt ALKALINE battery only (battery not included)

b. Install battery with correct polarity

(align "+" on detector housing with "+" on battery)

c. The battery cover opens and closes with a coin or screwdriver

2) Set the On switch to "ON"

"ON" is the middle position

3) Set the Audio/Vibrate Switch to "AUDIO"

4) Sweep the Detector over the target area.

Detector must be IN MOTION to detect metal

Batteries

Use 9-Volt ALKALINE battery only (battery not included)

Low Battery Alert

The Yellow LED indicator light will illuminate and remain illuminated when the batteries

are discharged to the point at which the detector has lost 10% of its metal detecting range.

The detector will continue to operate, at a lower sensitivity, when the Low Battery

Indicator is illuminated. Replace battery as soon as possible after the indicator illuminates.

If you plan to store the Handy Man Nail Finder™

for several days or more,

remove the battery.

" Polarity Side for Battery