AirSep FreeStyle 5 Patient Manual page 37

portable and mobile RF communications equipment and the FreeStyle 5
The FreeStyle 5 is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of
the FreeStyle 5 can help prevent electromagnetic interference by maintaining a minimum
distance between portable and mobile RF communications equipment (transmitters) and the FreeStyle 5 as recommended below, according to
the maximum output power of the communications equipment.
Rated maximum output
power of transmitter
from 150kHz to 80MHz
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the
equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in Watts (W) according to the
transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures,
objects and people.
Guidance and manufacturer's declaration - electromagnetic emissions
The FreeStyle 5 is intended for use in the electromagnetic environment specified below. The customer or the user of the FreeStyle 5 should
assure that it is used in such an environment.
Emissions test Compliance
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
MN166-1 rev A 11/12
Recommended separation distances between
Separation distance according to frequency of transmitter
from 80MHz to 800MHz
P
d= 1.2 x
0.12
0.38
1.2
3.8
12
Electromagnetic Environment guidance
The FreeStyle 5 uses RF energy only for its internal function. Therefore, its RF emissions
are very low and are not likely to cause any interference in nearby electronic equipment.
Group 1
The Freestyle 5 is suitable for use in all establishments, including domestic establishments
Class B
and those directly connected to the public low-voltage power supply network that supplies
buildings used for domestic purposes.
Class A
Complies
(m)
from 800MHz to 2.5GHz
P
d= 1.2 x
0.12
0.38
1.2
3.8
12
P
d= 2.3 x
0.23
0.73
2.3
7.3
23
33