AirSep FreeStyle 5 Patient Manual page 12

When connected to AC or DC power, the unit's battery charges until it reaches full capacity, either while the unit is
operating or turned off.
If the internal battery fully depletes and the FreeStyle 5 unit shuts down, the unit cannot be restarted with the AirBelt.
Should this occur, connect your FreeStyle 5 to its AC or DC power supply for a short period of time in order to provide
sufficient internal battery power to start the unit. AirBelt can then be connected to provide additional run time.
If the FreeStyle 5 power supply remains connected when the battery is fully charged, the four LEDs will turn off within 2 ½
hours.
It may be necessary to initially connect the AC or DC FreeStyle 5 power supply to the FreeStyle 5 unit before the unit will
operate for the first time on battery power. Your Equipment Provider may have already performed this step for you.
Use only AirSep Part No. FI194-1 for air intake filter for this unit.
Do not operate FreeStyle 5 without the air intake filter in place. If a second filter is provided, insert the "replacement" filter
before you clean the dirty filter.
AirSep does not recommend the sterilization of this equipment.
Do not attempt any maintenance other than the possible solutions listed within this manual.
Portable and mobile RF communications equipment can effect medical electrical equipment.
MN166-1 rev A 11/12
8