Set Up - RedMax EXTREME EXZ2450S-PH Owner's/Operator's Manual

EXZ2450S-PH

6. Set up

■ MOUNTING ENGINE (SE1)
1. Push the driveshaft housing toward the
clutch housing and rotate it by hand to
SE1 check that the driveshaft is engaged
with the gears.
2. Insert the driveshaft housing into the
clutch housing until it bottoms, and
align the positioning holes on the clutch
housing and the shaft tube and install
the screw. When difficult to engage,
twist the engine slightly.
3. Fasten the clamp securely with two
screws.
Tighten the screws gradually by turns.
■ CONNECTING THROTTLE WIRE
SE2
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to
the joint on the top of the carburetor.
(SE2)
■ CONNECTING SWITCH WIRES
• Connect the switch wires between the
engine and the main unit. Pair the wires
of the same color.
■ INSTALLING HANDLE
SE3
(BC-EX2, LRT-EX only) (SE3)
• Install the handle to the shaft tube and
clamp it at a location that is comfortable
to you.
(1)
(1) About 19 inches (48 cm)
(RMS-EX only) (SE4)
SE4
1. Remove both screws from the handle.
2. While spreading the handle at the
mounting hole, position the handle on
the outer tube as shown.
3. Reinstall the two mounting screws in
the handle, but do not tighten them at
this time.
One side of the handle is recessed to
receive the hex nuts.
4. Locate the handle at the best position
for operator comfort (usually about
US-10
IMPORTANT
NOTE
10inches (25cm) ahead of the throttle
lever), and secure it by tightening the
knob at the handle base.
SE5
■ JOINT ATTACHMENT (SE5)
(1)
• Insert the attachment to the main shaft.
• Tighten the knob bolt securely.
(1) Knob bolt
(BC-EX2 only)
■ INSTALLING DEBRIS GUARD
BC-EX2 SE1
• Put the debris guard on the gear box,
attach it with the screws and hardware
provided. (SE1)
■ INSTALLING LINE HEAD (SE2)
BC-EX2 SE2
1. While locking the gear shaft, by
inserting the supplied tool into the
upper holder on the gear box, loosen
and remove the hexagon nut(left-
handed)
2. Fit the line head assembly to the gear
shaft over the holders. Hand-tighten it
securely.
■ BALANCE UNIT
BC-EX2 SE3
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit
balances with head just touching on the
ground. (SE3)
(LRT-EX only)
■ ATTACHING THE TRIMMING
MECHANISM (SE1)
1. Remove the screw screwed into the
end of the trimming mechanism.
LRT-EX SE1
2. Insert the end of the trimming
mechanism into the main pipe.
3. Line up the hole on the end of the
trimming mechanism into which the
screw is to be inserted with the hole on
the main pipe, and screw the screw
firmly in.
4. Using a wrench, screw in the bolt