Reinstall Harness - Safety 1st Alpha Omega Elite Owner's Manual

Reinstall Harness

Reinstall Harness: Fit the
1
buckle strap down through
the slot in the seat. Make
sure buckle faces out.
You
1
1st or 2nd buckle
2
strap slots when rear-
3
facing. Any slot can
be used for forward-
facing.
With the child restraint
2
fully reclined, reach under
seat and pull buckle's
metal retainer completely
through pad and shell.
Pull up on the buckle to
3
make sure it is secured.
The buckle must not
pull out.
WARNING
!
Failure to place buckle's metal plate
completely through pad and shell can
result in serious injury or death to the
child.
46
4358-5834A 40lb Elite.indd 49-50 4358-5834A 40lb Elite.indd 49-50
4
MUST use the
5
Thread the harness down
6
through slot on left side
of shell (1), across bottom
of seat
slot on right side (3).
5
Thread one latch plate
onto harness from back
to front (4). Thread the
4
1
chest clip (5). Do the same
to the other harness end.
3
Make sure the harness is
not twisted.
2
Push harness ends through
upper slots in shell (6).
NOTE:
the harness strap across
the bottom of the shell,
make sure the harness
adjustment strap is
between the shell and the
harness strap as shown.
All straps should not be
twisted.
WARNING
!
Failure to reattach the harness correctly,
can result in serious injury or death.
Pull harness through the
back. Make sure the
harness goes OVER the
metal bar.
47
(2) and up through
When threading
continued on next page.
6/5/14 10:18 AM 6/5/14 10:18 AM