Latch - Safety 1st Alpha Omega Elite Owner's Manual

Forward-Facing Installation with
LATCH Belt: Install LATCH Belts
NOTE:
1
LATCH system along
with the adult lap or lap/
shoulder belt.
Route LATCH belt
through upper slot in side
of shell.
Pull one LATCH hook
2
across the back and out
the other side.
The LATCH adjuster can
be on either side, but the
belt should not be twisted.
Connect and tighten
3
harness straps prior to
installing in vehicle.
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.
The recline position is to
be used only to install the
child restraint flush against
the back of the vehicle seat
back, if needed.
36
4358-5834A 40lb Elite.indd 39-40 4358-5834A 40lb Elite.indd 39-40
4
Do not use
5
6
Fasten one LATCH belt
hook to the anchor in
the vehicle seat located
in the vehicle seat bight.
Repeat for other side of
child restraint. See your
vehicle owner's manual
for locations and more
information.
Push down firmly while
pulling up on the loop to
tighten belt.
With knee still in child
restraint, attach hook to
anchor in vehicle. Push
down firmly and tighten
top anchorage strap.
To adjust top anchorage
strap: See "Adjusting
Top Anchorage Strap"
section.
37
continued on next page.
6/5/14 10:18 AM 6/5/14 10:18 AM