Connecting The Management Interface; Connecting Interface Ports To Other Devices - Cisco Nexus 9348GC-FXP NX-OS Hardware Installation Manual

Connecting the Switch to the Network

Connecting the Management Interface

Before You Begin
To prevent an IP address conflict, you must complete the initial configuration and establish an IP address for
the switch.
Step 1 Connect the appropriate modular cable to on the switch.
Step 2 Connect the other end of the cable to the switch, hub, or router.

Connecting Interface Ports to Other Devices

After you perform the initial configuration for the switch and create a management connection, you are ready
to connect the interface ports on the switch to other devices. Depending on the types of interface ports on the
switch, you will need to use interface cables with QSFP+, SFP+, or SFP transceivers or RJ-45 connectors to
connect the switch to other devices.
The transceivers used with many fiber-optic cables come separated from their cables. To prevent damage to
the fiber-optic cables and their transceivers, we recommend that you keep these transceivers disconnected
from their fiber-optic cables when installing the transceiver in the interface port. Before removing a transceiver
for a fiber-optic cable, you must remove the cable from the transceiver.
To maximize the effectiveness and life of your transceivers and optical cables, do the following:
• Wear an ESD-preventative wrist strap that is connected to an earth ground whenever handling transceivers.
• Do not remove and insert a transceiver more often than is necessary. Repeated removals and insertions
• Keep the transceivers and fiber-optic cables clean and dust free to maintain high signal accuracy and to
• Clean these parts before installation to prevent dust from scratching the fiber-optic cable ends.
• Clean the connectors regularly; the required frequency of cleaning depends upon the environment. In
• Do not touch the ends of connectors. Touching the ends can leave fingerprints and cause other
• Inspect routinely for dust and damage. If you suspect damage, clean and then inspect fiber ends under
The switch is typically grounded during installation and provides an ESD port to which you can connect
your wrist strap.
can shorten its useful life.
prevent damage to the connectors. Attenuation (loss of light) is increased by contamination and should
be kept below 0.35 dB.
addition, clean connectors if they are exposed to dust or accidentally touched. Both wet and dry cleaning
techniques can be effective; refer to your site's fiber-optic connection cleaning procedures.
contamination.
a microscope to determine if damage has occurred.
Cisco Nexus 9348GC-FXP NX-OS Mode Hardware Installation Guide
Connecting the Management Interface
33