Cisco Nexus 9348GC-FXP NX-OS Hardware Installation Manual page 33

Installing the Switch Chassis
1 Slider rail with screw holes aligned to screw holes in
rack
c) Repeat Step 3 to attach the other slider rail to the other side of the rack.
To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count
the screw holes in the vertical mounting rails.
Step 5 Insert the switch into the rack and attach it as follows:
a) Holding the switch with both hands, position the two rear rack-mount brackets on the switch between the rack or
cabinet posts that do not have slider rails attached to them (see the following figure).
1 Align the two rear rack-mount bracket guides with
the slider rails installed in the rack.
2 Slide the rack-mount guides onto the slider rails until
the front rack-mount brackets come in contact with
the front rack-mount rails.
b) Align the two rear rack-mount guides on either side of the switch with the slider rails installed in the rack. Slide the
rack-mount guides onto the slider rails, and then gently slide the switch all the way into the rack until the front
rack-mount brackets come in contact with two rack or cabinet posts.
2 Two customer-supplied 12-24 or 10-32 screws used
to attach each slider rail to the rack
3 Front-mount brackets.
4 Mounting rails on rack or cabinet posts.
Cisco Nexus 9348GC-FXP NX-OS Mode Hardware Installation Guide
Installing the Switch
23