User Interface - Philips DVDR3577H/05 Service Manual

Reference : SGP_AVS_SW_ATLAS-05-05
Version : 0.17
Status : Proposed
Date : 2006-09-12

2 USER INTERFACE

1
The table below shows an overview of the user interfaces of the DSW. The table is based on
2
logical interface, interfaces as seen from user perspective. A logical interface can use one or
3
more physical interface components.
4
The DVD Recorder has only a single RS232 port (service port) available for diagnostic or
5
debugging purposes, implying that all interfaces using this port are mutually exclusive.
6
7
Logical
Interface
Command line
interface
Scripts
interface
8
In the next chapters the logical user interfaces are described in more detail including the exact
9
use of the physical interface components. To switch between interfaces, the DVD Recorder
10
needs to be switched off and on again.
11
2.1 NUCLEI NUMERATION
12
Each nucleus has a unique number of four digits. This number is the input of the command line
13
interface.
14
15
16
The following groups are available for the LeCo+ DSW:
17
18
19
Group number
0
1
2
3
4
5
6
7
9
12
© Philips Electronics N.V. 2006
Description
Used to send commands from the
Control PC or Service PC to the
DVD Recorder DS.
Used to execute End-user/Dealer
Test Script.
Figure 1 Unique number of a diagnostic nucleus.
Group name
Scripts
Codec (e.g. LeCo+)
Boot EEPROM
NVRAM (EEPROM of FLASH)
SDRAM (or DDR-RAM)
FLASH
Video Input Processor
DVIO
Basic Engine
System
Classification : COMPANY RESTRICTED
Project : ATLAS_DSW
Chapter : User Manual
Section : Diagnostic Software (Leco+)
Physical interface components
•
Control PC or service PC,
running a program (e.g. Asterix,
Compair,
connected to service port of the
DVD Recorder
•
Test pin
•
Local-Keyboard
•
Local-Display
Philips Semiconductors
HyperTerminal),
Page 8 of 124