Configuring Mode Vc-1X; Configuring Au-3-Tug-2-Vc-11-T1 - Cisco NCS 4200 Series Configuration Manual

Configuring Modes under AU-3 Mapping
Configuring AU-3 — VC-3 — E3
To configure AU-3 — VC-3 — E3:
enable
configure terminal
controller sdh 0/0/16
rate stm4
au-3 1
mode e3
cem-group 100 unframed
end
Configuring Modes under AU-3 Mapping
This section describes the configuration of modes under AU-3 mapping.

Configuring Mode VC-1x

To configure mode VC-1x:
enable
configure terminal
controller sdh 0/0/16
rate stm4
au-3 1
mode VC1x
tug-2 1 payload VC11
tug-2 2 payload VC11
tug-2 3 payload VC11
tug-2 4 payload VC11
tug-2 5 payload VC11
tug-2 6 payload VC11
tug-2 7 payload VC11
end
end
Configuring AU-3 — TUG-2 — VC-11 — VC
To configure AU-3 — TUG-2 — VC-11 — VC:
configure terminal
controller MediaType 0/0/16
mode sdh
controller sdh 0/0/16
rate stm4
au-3 1
mode vc1x
tug-2 1 payload vc11
vc 1 cem-group 10 cep
end
Configuring AU-3 — TUG-2 — VC-12 — VC
To configure AU-3 — TUG-2 — VC-12 — VC:
configure terminal
controller MediaType 0/0/16
mode sdh
controller sdh 0/0/16
rate stm4
1 port OC-48/ 4 port OC-12/OC-3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
IOS XE Fuji 16.7.x (Cisco NCS 4200 Series)
16
Configuring SDH