King Quest VQ4100 Quick Reference Manual page 2

3
Set up TV and receiver.
4
Make connections 1-3 in the order shown.
Place the power injector
in an accessible location.
When all connections are made, the antenna unit will scan for the DIRECTV 101 satellite.
When the satellite is found, your programming will appear. Enjoy!
The antenna unit begins scanning when you plug in the power injector.
If you wish to start a new scan (for example, the unit gets moved and you lose reception): press the power injector's
RESET button. This is the preferred method to start a new scan, but there are two alternate methods as well:
• Disconnect and reconnect the coax from the MAIN port on the antenna unit.
• Press the RESET button on the receiver (this option works for select receivers only, such as models D12, H24,
and HR24).
DIRECTV is a registered trademark of DIRECTV, L.L.C. KING Quest is a trademark, and KING is a registered trademark of Electronic Controlled Systems, Inc. which is not affi liated with DIRECTV, L.L.C. 21962 Rev A
Do not over tighten the coax connections.
Do not route the coax cable where it can be tripped on or run over by a vehicle.
Do not put sharp bends or kinks in the coax cable.
DO NOT MOVE THE ANTENNA UNIT WHILE IT IS SCANNING.
The KING Quest will not work with SWM only
receivers. For a list of compatible receivers,
see www.kingconnect.com/dtv-receivers.
All components sold separately.
Plug in power supply last.
Do not move antenna unit after
plugging in power supply as the
antenna has begun scanning.