Page 1
MODEL 2610 10 AMP ON BOARD BATTERY CHARGER Two Output OWNER’S MANUAL Connections at a glance: For the best charging results both 12 Volt independent batteries should be equally discharged. The charger will supply 5 Amps to each battery output for a total of 10 Amps. When unequally discharged batteries are connected to the outputs, the charger will automatically steer more current to the battery that needs it.
The GUEST ChargePro 2610 is designed to both recharge your batteries, and extend your battery’s life in applications where it is stored for long periods of time. The 2610 is a “3-stage” electronic battery charger with two independent outputs. Rainproof, lightweight, silent, and completely automatic, it produces 12 Volts DC at a full 10 Amps, while using much less AC current than older chargers.
Preparing to Charge Precautions Before charging a battery with the charger, read the following precautions: 1. Do NOT operate the charger if a power cable or an LED is damaged. 2. Make sure all accessories on the product you are charging are OFF. 3.
If the red LED stays on for more than 24 hours, refer to Problem 1 in the troubleshooting section in this manual. When both the green and the red LED’s are on, the 2610 is charging at an "ABSORPTION" rate of between 3 and 9 Amps (stage 2). This mode of charging gradually "tops off"...
1. No AC power available 1. Connect AC power or reset the AC LED’s turn on at the charger. breaker on the main panel. when the AC power is applied. 2. Component failure 2. Return charger to the Guest Service Dept.
LIMITED WARRANTY For two (2) years from the date of original purchase, The Guest Co. will, at its discretion, repair or replace for the original consumer, free of charge, any parts found defective in material or workmanship. All transportation charges under this warranty must be borne by the consumer.