Preparing To Charge Precautions; Grounding Precautions; Installing The Charger; Mounting The Charger - Guest 2610 Owner's Manual

Preparing to Charge Precautions

Before charging a battery with the charger, read the following precautions:
1. Do NOT operate the charger if a power cable or an LED is damaged.
2. Make sure all accessories on the product you are charging are OFF.
3. If the battery or batteries must be removed from the product, always remove the grounded
terminal from the battery first.
4. Be sure the area around the battery is well ventilated while the battery is being charged. Gas
can be forcefully blown away using a piece of cardboard or other non-metallic material as a
"hand fan".
5. Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.
6. Add distilled water in each cell until battery acid reaches levels specified by the battery
manufacturer.
manufacturer's recharging instructions.
7. Never allow the ring terminals to touch each other.
8. NEVER charge a frozen battery.

Grounding Precautions

Do not operate this charger with a two bladed adapter plug or extension cord. Doing so
can result in serious personal injury.
CAUTION: To reduce the risk of shock, connect only to a properly grounded outlet.

3. INSTALLING THE CHARGER

Choosing Charging Location
The charger should have at least eight inches of unobstructed area on all sides of the unit for
effective cooling. The case of this charger will become warm during operation. Do not install the
charger on carpeted, upholstered, or varnished surfaces.

Mounting the Charger

1. Use corrosion resistant #10 dia. bolts, backed by a flat washer, and secured to the mounting
surface with a split-ring lock washer.
2. Hold the charger to the mounting surface and mark the holes.
3. Remove the charger and drill the mounting holes.
4. Align the charger and assemble the mounting hardware. Secure.
Making DC and AC Connections
We require using a 15 amp fuse P/N AGX-15 or equivalent on the DC side as pictured below.
fuse holder
Do not overfill. For a battery without cell caps, carefully follow the
DANGER
6"
3
+