Advertisement
Connections at a glance:
The Guest MTC Model 2606A is designed to be used as a general purpose charger for lead acid
batteries (flooded cell or AGM types) and gel cell batteries. We recommend that you set up the
charger near the battery you wish to charge, and make connections in the following order:
1. Charger POS (red wire with fuse) to battery " + ".
2. Charger NEG (black wire) to battery " – ".
3. Plug AC line cord into a GFCI protected wall socket.
4. Remove connections in the reverse order.
MODEL 2606A
MODEL 2606A-B
6 AMP PORTABLE BATTERY CHARGER
OWNER'S MANUAL
2606
A
SAVE THESE INSTRUCTIONS
R
12V BATTERY
+
-
Advertisement
Table of Contents
Related Manuals for Guest 2606a
Summary of Contents for Guest 2606a
- Page 1 OWNER’S MANUAL Connections at a glance: The Guest MTC Model 2606A is designed to be used as a general purpose charger for lead acid batteries (flooded cell or AGM types) and gel cell batteries. We recommend that you set up the...
-
Page 2: Introducing The Charger
1. INTRODUCING THE CHARGER The GUEST MTC 2606A is designed to both recharge your battery, and extend your battery’s life in applications where it is stored for long periods of time. The 2606A is a “3-stage” electronic battery charger. Rainproof, lightweight, silent, completely... - Page 3 Personal Safety Precautions Adhere to the following personal safety precautions when installing or working with the chargers: Someone should be within voice range or close enough to come to your aid when you work near a lead-acid battery. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
-
Page 4: Installing The Charger
8. Please be sure the DC system to which the charger is connected is not drawing excessive current from the battery for extended periods of time while the charger is operating. This is important to ensure the charger correctly transitions through each charging stage to finish with the float voltage level. -
Page 5: Operating The Charger
If the red LED stays on for more than 24 hours, refer to Problem 1 in the troubleshooting section in this manual. When both the green and the red LED’s are on, the 2606A is charging at the "FINISHING" rate. (stage 2). During this... - Page 6 When the green LED is on, the 2606A is charging at a "FLOAT” or “MAINTENANCE" rate of less than 1.5 Amps, (stage 3). Your battery is now 90% charged and ready for Green use. This "float" charging current will gradually decrease to as low as 0.1 Amps as the battery reaches 100% charge.
-
Page 7: Troubleshooting
1. No AC power available at the 1. Connect AC power or reset the AC LED’s turn on charger breaker on the main panel when the AC 2. Component failure 2. Return charger to the Guest Service power is Dept. applied. -
Page 8: Maintaining The Charger
2.1 in. (5.3 cm.) Weight: 3.5 lb. (1.6 kg) Guest Model 2606A Charging Metho FCC Class B EMC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. - Page 9 LIMITED WARRANTY For two (2) year from the date of purchase, The Guest Co. will, at its discretion, repair or replace for the original consumer, free of charge, any parts found defective in material or workmanship.