Table of Contents
Advertisement
Setup and Connections
The Basic connection (pip not available)
The basic connection below (TV and VCR) is the most common
connection and is therefore used to illustrate a single component
connection with your TV. For better sound and picture quality and
multiple component connection information refer to the next section,
Advanced Connections.
Cables
You will use the following cable to make your connection:
Coaxial Cables: These cables carry both the audio
and video signal to the TV from an antenna, cable,
or cablebox. In this connection, a second Coaxial
Cable carries the signal through the VCR to the TV.
CABLE, CABLE BOX, OR ANTENNA
VCR 1
OUT
VIDEO
AUDIO
TV
SPEAKER
SELECTION
EXTERNAL INTERNAL
SPEAKERS
INPUT 2
INPUT 1
VIDEO
L—AUDIO—R
VIDEO
R
R
AUDIO
AUDIO
L
L
S-VIDEO
AUDIO OUTPUT
Once you have completed this connection you may skip to Step 3,
"Connecting the IR Controller."
IN FROM ANT
CH3
CH4
OUT TO TV
+
-
+
-
RIGHT
LEFT
S-VIDEO
VCR
CONTROL
CABLE/
ANTENNA
INPUT
This Connection Will Not Allow
You to Use PIP
Your TV is equipped with a single tuner
which means you must connect with a
second video source using Audio/Video
Cables. This Basic Connection will not
enable you to use your PIP, but will get
your TV up and running quickly.
Refer to Advanced Connections for
connecting Audio/Video cables to your
VCR or other video component.
How to View the VCR
To watch the VCR in this connection tune TV to
Channel 3 or 4.
Later, in the Interactive Setup section you will
program the TV to automatically tune to Channel 3 or
4 when you turn on the VCR.
5
Advertisement
Table of Contents
