Module Descriptions; The Front Part Of Module - OSEE HDX6811N User Manual


One channel HDMI output monitoring

A variety of available signal sources for each audio output

Video input auto-detect and input status feedback

Support 20-bit and 24-bit audio processing

Support 8-channel audio metering display

Generate Text signal at fixed frequency rate

Support maximum 2.7 seconds audio delay, invert and mute

Support the audio gain adjust, inverted, silencers, exchange processing

EDH /CRC error detection tracking and re-insertion

Built-in video detection signal generator, and built-in audio test signal

Video loss, freeze frame, black field detection

Provide network control functions, for the local and remote set of modules
FCC Caution
:
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.

1.3 Module Descriptions

1.3.1 The Front Part of Module

Figure 1-1 shows the control switch and LED indicator in front of the module
HDX6811N/HDX6812N.
HDX6811N/HDX6812N HD Audio De-embedder
2
User Manual