The user manual applies to the following device types: AURORA1600 The images of AURORA1600 adopted in the following descriptions. Any of the different specifications between the device types are elaborated. Before reading the manual, please confirm the device type.
Product Overview Chapter 1 Product Overview This article is mainly about AURORA1600, developed by OSEE with high intelligent, which applied the 1U Multi-image Processor, which performs multi-channels input signals displayed on one screen for surveillance. It attaches, switches and zooms the video sources, and provides ideal visual effect, flexible operation environment and easiness for configuration and maintenance.
Page 8
Product Overview Support up to 1920*1080 through one single output interface Support up to 16 displays in a single screen Support up to 4K resolution through four combined output interfaces per 50/60 frame rate All modules are redundant designed, and support online replacement ...
Page 9
Product Overview HDMI Remote Control Computer Router Figure 1-2 The Topology of AURORA1600 3 ...
Safety Chapter 2 Safety FCC Caution Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 12
Safety Warnings: Read, keep and follow all of these instructions for your safety. Heed all warnings. Multi-image Processor Upgrading of the device is subject to change without notice. Contact your Customer Service representative if parts are missing or damaged.
Unpack When unpacking the components of this switcher, please verify that none of the components listed in Table 3-1 are damaged or lack. If there is any missing, contact your distributors or OSEE for it. Table 3-1 Packing List Item...
Page 14
Unpack and Installation If the original package is not available, you can supply your own packaging as long as it meets the following criteria: The packaging must be able to withstand the product’s weight. The product must be held rigid within the packaging ...
Page 15
Pin3(Rx-) and Pin5(Tx-), Pin4(Rx+) and Pin6(Tx+) by twisting the corresponding wires of the network cable. Secondly, power on the AURORA1600 and keep it running for at least 60 seconds, thus, the IP address of AURORA1600 will be restored to the default one.
AURORA1600 Features Chapter 4 AURORA1600 Features This chapter describes the features of AURORA1600. 4.1 Front Panel Features There are two indicators in the center of the front panel, as shown in Figure 4.1-1 Figure 4.1-1 the Buttons in Front Panel Production Information It shows the basic information of the production: LOGO and model.
AURORA1600 Features 4.2.1 Arrangement of Rear Connectors As shown in Figure 4.2-1, AURORA1600 provides the various connectors for power supply, input, output and control, the details are as below: Figure 4.2-1 The Rear Connector of AURORA1600 Power Input: PS1, PS2...
Page 19
AURORA1600 Features your safety! LTC Input (BNC) It provides one LTC input interface to connect to a LTC timing device, it is labeled as LTC IN. The LTC timing code is used to time the analog clock timer or digital clock timer.
Page 20
The default IP address of AURORA1600 is 192.168.1.70. Restore the default IP setting by short-circuit two pairs of the corresponding pins of RS422 interface at the rear panel.
Page 21
AURORA1600 Features Figure 4.2-5 The Pins Sequence of RS422 Connector Figure 4.2-6 The Pins Sequence and Functionalities of RS422 Connector Table 4.2-2 The Relationship of Pins and Values for RS422 Pins Value GPIO(DB26) It provides one GPIO interface to realize the remote control function, and you can set a function value to each appointed pin.
Page 22
AURORA1600 Features Table 4-3 The Relationship of Pins and Values for GPIO Pins Value Pin1~Pin16 GPI1~GPI16 Pin17~Pin22 Pin23 GPO4 Pin24 GPO3 Pin25 GPO2 Pin26 GPO1 Video Output Interface (HDMI) It provides 4 video output interfaces to receive and send HDMI/DVI signals.
Page 23
AURORA1600 Features Pins Value Pins Value Pin7 AUDIO IN15 Pin20 AUDIO IN13 Pin8 AUDIO IN4 Pin21 Pin9 Pin22 Pin10 AUDIO IN5 Pin23 Pin11 Pin24 AUDIO IN16 Pin12 AUDIO IN14 Pin25 Pin13 AUDIO IN6 Pin26 AUDIO IN12 Audio Output Interface (DB26) It provides one audio output interface, it is labeled as AUD OUT 1~4.
1080i50/59.94/60, 1035i59.94, 1035i60, 1080p23.98/24/25/29.97/30, 1080sf23.98/24 3G-SDI: 1080p50/60/59.94 4.2.3 Timing AURORA1600 provides the following timing methods: LTC and native timing (administration side). LTC Timing Use LTC timing through LTC port, the conditions are as below: (1) Connect a LTC timing device through the LTC port. The LTC external...
Figure 4.2-12 Timing Operation Window 4.3 Control Access The AURORA1600 is connected to its remote control computer through the Ethernet interface using the twisted-pair cable. Start up the computer and run the multi-image control software, and the software will load the information of the multi-image after setting up the connection.
Page 26
AURORA1600 Features multi-image control software, the software interface is shown in Figure 4.3-1: Figure 4.3-1 The Interface of the Multi-image Control Software Refer to "The Manual for the Multi-image Controller Software " for details. 20 ...
Specifications Chapter 5 Specifications Product detailed information Specification Values input 16 channels of 3G/HD/SD-SDI input Input characteristic module with 16 signals input channels Input module 3G/HD/SD-SDI input signal output Output 4 channels of SDI/HDMI output signal module with 4 characteristic output channels Output module SDI/HDMI output signal...
Page 28
<135 ps for 3 Gb/s HD Extinction Ratio >8 Back Reflection <-14 dB 2. Product Outline The outline of AURORA1600 is shown as in the following figures: Figure 5-1 Front Panel(Unit: mm) Figure 5-2 Rear Panel(Unit: mm) Figure 5-3 Side View(Unit: mm) 22 ...
Page 29
Specifications Figure 5-4 Top View(Unit: mm) Specifications are subject to change without notice. ------------------No Text Below------------------ 23 ...
Page 31
FOR MORE INFORMATION PLEASE VISIT: http://www.osee-dig.com/ OSEE TECHNOLOGY CO., LTD. No.22 Building, No.68 zone, Beiqing Road, Haidian District, Beijing, China Tel: (+86) 010‐62434168, Fax: (+86) 010‐62434169 E-mail: sales@osee-dig.com...