Table of Contents
Advertisement
Locate the position for back connector and insert the back connector.
Fasten the screw to fix the back connector.
Locate the slot for module.
Get the module installed in the slot, push the module slightly along the slot, press module
again to confirm that the module is installed firmly and then close swivel handle.
Install the front panel.
2.5 Making the Connections
Please connect signals based on Fig. 1-3.
2.6 Removing the Module
Follow the following steps to remove the modules:
1.
Open the front part of frame.
2.
Open the swivel handle to the full.
3.
First make sure the frame stands firmly, and then pull the module gently along the slot
till out of frame.
4.
Install the front panel.
Chapter 3 Operation and Control
3.1 Switches
The control switch is shown in Figure 3-1.
1.
SW1
HDX6811N/HDX6812N HD Audio De-embedder
Fig. 2-1 Installation of 2U Frame of 6800N Series
Fig. 3-1 Switches and Key
8
User Manual
Advertisement
Table of Contents
