Resetting The Boiler
There are two types of errors that can be found on the controller:
Fault and Block.
Fault:
If a fault occurs, the display shows
The fault is identified by the error code followed by the letter "E" and is not resettable
unless the problem is corrected.
Block:
If a block occurs, the display shows the
<>>>OK> symbols alternating.
The block fault is identified by an error code (see the table below) followed by the letter "E".
Press the OK button on the controller to reset the boiler. The display shows the
<RESET> writing followed by the >>>OK writing.
symbols flashing with the writing <ERROR>.
symbols flashing together with the <ERROR> and
ii