Advertisement
WARRANTY NOTE
Equipment manufactured by Noztek carries the standard machine tool guarantee
of freedom from defects in workmanship and material for one year from date of
shipment.
TO INSURE THAT YOUR WARRANTY IS HELD IN EFFECT, PROPER
OPERATION PROCEDURES MUST BE OBSERVED.
NOTE: READ THE SAFETY PRECAUTIONS BEFORE OPERATING THIS
MACHINE.
GENERAL SAFETY NOTES
Know your equipment
Carefully read the instruction manual.
Learn the use and limitations of the equipment.
DO NOT operate or use this equipment for any purpose other than its intended
use.
DO NOT modify this equipment.
DO NOT perform adjustments or maintenance while system is operating or
energize
Do not clean the equipment with flammable solvents.
Do not wash down the equipment with water. This could cause an electrical
hazard.
Do not probe into extruder vent with the machine running. Never Use a metal
probe in the vent area. The screw may shear the probe, causing extensive
damage to the barrel and screw. A wooden probe is recommended.
A face shield, insulated gloves, etc. should be worn around the extruder during
operation. They must be worn when adjusting the die, cleaning the screw, etc.
The extruder temperatures are extremely hot.
The feed hopper must be installed on the extruder feed section at all times when
in operation
Never put hands in the feed section or vent to remove material.
Do not switch on the motor until the recommended temperature has been
reached
2
Advertisement
