Whirlpool RF375PXW Use And Care Manual page 17

Replacing
Burn, Electrlcal Shock and Fire Hazard
l
Make sum all surface unlts are OFF before replacing surface unlts and
reflector bowls. Failure to do so can result In burns or electrical shock.
l
Do not llne the reflector bowls wlth toll. Fire or electrical shock
could result.
1.
Turn off all surface units.
2. Line up openings in the reflector
bowl and notches in the trim ring
with the surface unit receptacle
and the element hold down clip.
3. Hold the surface unit as level as
possible with me terminal just
started into me receptacle. Push
me surface unit terminal into the
receptacle.
4. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit
opposite the receptacle. The ele
ment hold down clip will keep the
surface unit from moving around.
NOTE: Reflector bowls reflect heat back to fhe utensils on the surface
units. They also help catch spills. When they are kept clean, they reflect
heat better and look new longer.
If a trim ring gets dlscolored, some of the utensils may not be flat
enough, or some may be too large for the surface unit. In either case,
some of the heat that's meant to go Into or around a utensil goes down
and heats the trlm ring. This extra heat can discolor it. See Cooklng
Gulde for further Information.
17