Tape-In For Rough Remix - Tascam M-35 Operation And Maintenance Instruction Manual

3. Tape-in for Rough Remix
MIC I N
1 x 0 1
EFFECTS RCV
EFFECTS RCV
EFFECTS RCV
EFFECTS RCV
EXPANDER INPUT
I
2
3
4
When the INPUT select switches on the modules
are set to the center position, the submaster
TAPE IN jacks are internally connected t o the
input modules. Selecting this remix position on
the input module will not disable the norma1
operation of the monitor. Signal will go to both
circuits a t the same time, allowing separate use
of the monitor outputs as extra mixes. True
stereo echo is an obvious first choice, and the
mixdown machine can be monitored using the
AUX IN position on the contro1 room monitor
module. Since the remix position can be selected
one module
a t a
time, a single track may be
equalized and monitored without disturbing
AUX OUT
1x41
TAPE l N
11-41
CUE OUT
11 I l
EFFECTS SEND
111 I
TAPE I N
15-81
mix to 2 track
MIC I N settings on the whole mix. A decision
can be made quickly on the artistic success or
failure of an individua1 part without the need t o
place the entire console in remix mode just t o
see the effect of corrective equalization on a
single track. Since the TAPE IN jacks on the
buss master moduels actually feeds 3 separate
mixing positions it will present a more severe
load to anything connected t o
it
than "Line in"
on the module. TAPE IN'S have an input load
impedance of 20k ohms and LINE IN'S (on the
input module) have an input impedance of 50k
ohms.