THOMSON TM580 User Manual page 30

Chapter 2
Local Network Setup
Installing Windows USB
Verifying USB
connectivity in Windows
Installing Mac USB
Device settings
22
The installation is plug and play, meaning that installation will require almost no
effort.
driver
Proceed as follows:
Insert the blue USB cable provided into the SpeedTouch™ USB port marked with
1
the USB logo:
The other end of the USB cable fits in (one of) the USB port(s) of your PC. In
2
most cases your PC's USB port is marked with the same USB symbol.
You can also connect your PC to the SpeedTouch™ via a USB hub.
Windows will automatically recognise the Thomson USB Remote NDIS device:
3
The Windows Found New Hardware Wizard appears:
4
This wizard will guide you through the installation procedure of the USB drivers.
Click Next to continue.
The Windows Found New Hardware Wizard may ask your
authorisation to connect to Window Update to search for software. If
this is the case, select No, not this time and click Next.
Select Install the software automatically (Recommended), and click Next.
5
The USB driver is being installed. After a while a completing dialogue will
6
appear. Click Finish to complete the installation.
As a result your USB connection is installed and ready for use.
7
The SpeedTouch™ USB connection is represented as a local network interface. You
can easily check this interface by opening the Network Connections window from
Windows' Control Panel:
The USB driver will be installed automatically on your Mac.
drivers
On the Setup CD, the Mac USB driver is located in stInstall.app > Contents >
MacOS > CDCdriver.
Once you've connected a device, you are able to personalise its settings. For more
information, see " Device settings" on page 19.
E-DOC-CTC-20050429-0102 v1.0