Juta CM3024Z Installation And Operation Manual page 5

JUTA Solar Charge Controller
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
This interface is the main interface, and it shows the charging & discharging state,
battery capacity and battery voltage.
3.2 Load ON/OFF controlling
At the battery voltage review interface, you can press button
load, while this button does not have this function at other interfaces.
3.3 Environmental temperature review
Be used for the temperature compensation when the battery ceases charging.
As shown as the right figure, the displaying number is the surrounding
environmental temperature of the controller,
3.4 Review the generating current of solar panels
As shown as the right figure, the displaying number is the generating
current of solar panels.
3.5 The load current review
As shown as the right figure, the displaying number is the load
current.
3.6 Review and clearing the accumulative generating AH of solar
panels
As shown as the right figure, the displaying number is the accumulating
genera ting AH of sola
At this interface, press button
accumulative generating AH.
3.7 Review and clearing load accumulative discharging AH
As shown as the right figure, the displaying number is the acc
discharging AH of loads.
At this interface, press bu
accumulative discharging AH.
3.8 Review
As shown as the right figure, the displaying number is the p
voltage. And if the battery voltage is lower than this voltage, the
controller will disconnect the load loop to prevent the battery from
over-discharging.
At this interface, pr
and it means the controller enters into the interface of setting the protection voltage.
Use button
After finishing setting, press button
controller can store this setting number.
3.9 Review and setting recovering voltage for low voltage condition
As shown as the right figure, the displaying number is the recovery
number. After the controller enters into low voltage protection state,
and when the battery voltage recovers to be higher than the recovering voltage, then th
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Ningbo Star Solar Co.,Ltd Tel:(86)574 26266608 Fax:(86) 574 26266618 56664636 Email:Sales@pvsolarchina.com Http://www.pvsolarchina.com
r panels
(＞5 seconds), and it can clear
tton (＞5 seconds), and it can clear
and setting low voltage protection function
ess button
、 to adjust this parameter.
for long(＞5 seconds),the number starts to flicker,
for long(＞5 seconds) to exit this interface and the
Model :CM3024Z
to turn on or turn off the
umulative
rotection
e