Samsung VP-A12 Service Manual page 42

This remote control(accessory unit) is used to control the camcorder additionally, card remote control
(Parts No. AD59-10379A) should be used for adjustment of the camera section.
Remote for camcorder
Adjust for jig (Part No. : AD59-10379A)
START
/STOP
REW
PLAY
STOP
STILL
Note : In service adjustment mode, button names are different from those in customer camera function control
mode. EX) Start/stop button is the same as confirm.
5. How to get into service ÒADJUSTÓ mode
STEP 1
1. Remove the lithium battery from the
camcorder.
2. Connect the power source (battery/
DC cable).
3. Eject the tape if it is in the unit.
4. Set the power switch of the
camcorder to ÒCAMERAÓ position.
5. Set OSD on state.
On screen display show "E2 HALLA XX XX"
CAMERA ADJUSTMENT mode has successfully
been activated.
Note : When ÒXX XXÓ is shown in service adjustment precedures, this indicates variable values.
Samsung Electronics
F.F
DISPLAY
SELF TIMER
Figure of button placement when remote is
Reassignment
in the
adjustment mode
STEP 2
1. Press and hold ÒDATEÓ button on camcorder for
more than 3 seconds, then it goes into ÒCLOCK
SETÓ mode. One of the digits will blink.
2. PRESS ÒSTILLÓ Button 4 times on the camcorder
so blinks Ò00Ó on the screen.
3. Rotate the DSE dial on the camcorder
until ÒNEGAÓ shows on the screen.
4. Press and hold the ÒC/RESETÓ button and
ÒREWÓ button on the camcorder at the same time
for more than 3 seconds. Then unit goes into
service mode. ÒADJUST?Ó blinks on the screen.
This indicates that you are ready to adjust any
electronic variable resistors.
STEP 3
ÒADJUST ?Ó will now be blinking at the center of
screen. Now press ÒSTART/STOPÓ button of the
remote control.
Alignment and adjustment
used for service adjustment.
CONFIRM
MODE
DATA
DATA UP
DOWN
DOWN
FAR
NEAR
MODE
UP
OSD 12 :Ò00Ó: AM
1.JAN.1997
5-3