1. Manuals
  2. Brands
  3. Jands Manuals
  4. Controller
  5. 4Pak-D
  6. User manual

Jands 4Pak-D User Manual

Four channel controller/dimmer
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Supplied by:

Advertisement

Table of Contents
loading

Related Manuals for Jands 4Pak-D

Summary of Contents for Jands 4Pak-D

  • Page 1 Supplied by:...
  • Page 2 Information contained in this manual is subject to change without notice and does not represent a commitment on the part of the vendor. Jands Pty Limited shall not be liable for any loss or damage whatsoever arising from the use of information or any error contained in this manual.

  • Page 3: Before Use

    32-steps, forward, reverse, and bounce modes, crossfade mode, and the ability to trigger on the room sound via the inbuilt microphone. The 4Pak-D includes the ability to replay 5 scenes at once under the control of the 4 channel faders and the chase level fader.
  • Page 4 Layout Channel output sockets: The four output sockets connect to the lights. Overload circuit breaker: The circuit breaker protects the 4Pak-D from faults and overloading. Channel faders: These faders control the channel output levels. In scene mode these faders control the level of four scenes.

  • Page 5: Operation

    Deep Clear It is occasionally useful to clear out all user recorded scenes and chases and reset the unit to its defaults - this is achieved using the “Deep Clear” function. To Deep Clear a 4Pak-D: 1. Turn the power off.

  • Page 6: Scene Operation

    It is possible to delete all steps from a point onward for example, steps 5 and 6 of a 6 step chase. To delete all steps from step 5 onward Enter Chase record mode, select the first setp to be cut, then press and hold store for 3 seconds. The 4Pak-D flashes CUT and pressing Enter again confirms the deletion.

  • Page 7: Dmx Operation

    DMX or the fader, flash, chaser and scene controls (highest takes precedence). If DMX signal is lost the 4Pak-D will hold the last received value for 10 minutes, after which the DMX values will be driven to 0. The front panel controls will continue to operate as normal.

  • Page 8: Display Glossary

    Indicates the 4Pak-D will run factory programmed chase #1 when the Go/Load button is pressed. Indicates the 4Pak-D will run user programmed chase #2 when the Go/Load button is pressed. Indicates the 4Pak-D will run user programmed scene page #4 when the Go/Load button is pressed.

Table of Contents