Safety Information; Warnings - Fluke 7038 User Manual

7037/7038/7040/7041 Calibration Bath
User's Guide
1.2
1.2.1
2
Symbol Description
Canadian Standards Association
OVERVOLTAGE (Installation) CATEGORY II, Pollution Degree 2 per IEC1010-1 re-
fers to the level of Impulse Withstand Voltage protection provided. Equipment of
OVERVOLTAGE CATEGORY II is energy-consuming equipment to be supplied from
the fixed installation. Examples include household, office, and laboratory appliances.
C-TIC Australian EMC Mark
The European Waste Electrical and Electronic Equipment (WEEE) Directive
(2002/96/EC) mark.

Safety Information

Use this instrument only as specified in this manual. Otherwise, the protection
provided by the instrument may be impaired. Refer to the safety information in
Table 2.
The following definitions apply to the terms "Warning" and "Caution".
• "WARNING" identifies conditions and actions that may pose hazards to
the user.
• "CAUTION" identifies conditions and actions that may damage the in-
strument being used.

WARNINGS

To avoid possible electrical shock or personal injury, follow these guidelines.
GENERAL
DO NOT use the instrument for any application other than calibration work.
The instrument was designed for temperature calibration. Any other use of the
instrument may cause unknown hazards to the user.
DO NOT use the instrument in environments other than those listed in the
user's guide.
DO NOT overfill the bath. Overflowing extremely cold or hot fluid may be
harmful to the operator. See section 5.3, Bath Preparation and Filling, for spe-
cific instructions.
Follow all safety guidelines listed in the user's manual.
Calibration Equipment should only be used by Trained Personnel.
If this equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.