Table of Contents
Advertisement
ON•OFF
SAT•CABLE
TV
AUX
DVD
GO BACK
VOL
CH
FORMAT
MUTE
GUIDE
INFO
SUB
FORMAT
CH
MENU
CLEAR
INPUT
ANT•CABLE
REVERSE
PLAY
FORWARD
RECORD
STOP
PAUSE
remote model
r401a1
The darkened buttons are the device buttons
that can be programmed.
ON•OFF
SAT•CABLE
TV
AUX
DVD
GO BACK
VOL
CH
MUTE
GUIDE
INFO
SUB
FORMAT
CH
MENU
CLEAR
INPUT
ANT•CABLE
REVERSE
PLAY
FORWARD
RECORD
STOP
PAUSE
You'll use these darkened buttons for Direct
Entry.
Chapter
Programming the remote to Operate
ON•OFF
Other Devices
SAT•CABLE
TV
VCR
DVD
The universal remote can be programmed to operate many brands of remote-
AUDIO
AUX
controllable VCRs, audio devices, DVD players, cable boxes, satellite receivers
GUIDE
INPUT
ANT•CABLE
and other devices. In addition to being programmed to operate your television,
INFO
it's already programmed to operate some RCA devices.
A second and third RCA TV can be programmed to any device button, except
CLEAR
MENU
the TV button.
GO BACK
Notes: The TV button can't be programmed on this remote to control
VOL
CH
any device; it controls only this TV.
MUTE
The remote may not be compatible with all models of all brands of
devices. It also may not operate all functions of your device.
SKIP
SUBCHANNEL
Find Out If You need to Program the remote
REVERSE
PLAY
FORWARD
To determine whether the universal remote needs to be programmed to operate
one of the devices connected to your TV, such as a VCR, do the following:
RECORD
STOP
PAUSE
1. Turn on the device (in this example, a VCR).
CC
PRESETS
SOUND
2. Point the remote at the device.
remote model
r602a1
3. Press the corresponding device button (in this example, VCR).
4. Press ON•OFF to see if the VCR responds. If the VCR doesn't respond, you
need to program the remote to operate it.
Programming the remote
ON•OFF
There are three ways to program the remote control to operate other devices:
SAT•CABLE
TV
Direct Entry, Manual Code Search, and Automatic Code Search. If you have
VCR
DVD
recently purchased the device you want to control or if the device has many
AUDIO
AUX
codes, you might want to try the manual code search first.
GUIDE
ANT•CABLE
INPUT
FORMAT
INFO
Using Direct Entry
1. Turn on the device you want to control.
CLEAR
MENU
GO BACK
2. Look up the brand and code number(s) for the device in the code list at the
VOL
CH
end of this section.
MUTE
3. On your remote control, simultaneously press and hold the ON•OFF and
MUTE buttons (approximately 3 seconds) until a device button remains lit.
Then release the buttons.
4. Press and release the device button (SAT•CABLE, VCR, DVD, AUX or
SKIP
SUBCHANNEL
AUDIO) you want to program.
REVERSE
PLAY
FORWARD
5. Enter a three digit code from the code list.
RECORD
STOP
PAUSE
CC
PRESETS
SOUND
Using the Remote Control
Advertisement
Table of Contents
