RCA Scenium L26WD14 User Manual page 28

Using the TV's Features
Autotuning
Go back
Set VCR channel VID1...
Set DVD channel CMP1...
Set SAT•AUX HDMI1...
28
1668591B.indb 28 1668591B.indb 28
5. Press the right arrow button to select the choice that matches the
way you have the device connected to this TV.
You can select from the following inputs or channels:
N/A Choose this if you don't have this particular device connected
to the TV, or if you don't want the TV to automatically tune to the
correct channel/input when you're using this device.
Channel 3 or 4 Device is connected to the ANT/CABLE jack
on the back of the TV, and you want the TV to tune to channel
3 when you press the corresponding button on the remote.
Reminder: make sure the device's Channel 3/4 switch is set to
channel 3.
VID1 or VID2 (Video Input) Device is connected to the
VIDEO1 jack on the back of the TV or the VIDEO2 jack on the
side of the TV and you want the TV to tune to the VIDEO input
channel when you press the corresponding device button.
CMP1 or CMP2 (Component Video Input) Compatible
component video source, such as an HDTV tuner or satellite
receiver, is connected to the three COMPONENT VIDEO INPUT
jacks (Y Pb Pr) on the back of the TV and you want the TV to tune
to the component video input channel (CMP1 or CMP2) when you
press the corresponding device button.
VGA Device is connected to the VGA jack on the back of the TV
and you want the TV to tune to the VGA input channel when you
press the corresponding device button
HDMI1 or HDMI2 Device is connected to the HDMI1/DVI or
HDMI2 jack on the back of the TV and you want the TV to tune to
the HDMI input channel when you press the corresponding device
button.
Chapter 3
6/5/06 3:28:17 PM 6/5/06 3:28:17 PM