Advertisement
IFB-GL-932-60CM/90CM
Warranty Terms & Conditions
Valid for Chimneys/Built in Hobs/ Cook Tops/ Cooking Ranges/ Built in Ovens
IFB Industries Ltd. ("The Company") warrants to the original domestic purchaser of the
above mentioned products ("Appliances") that it is free from defect in workmanship and
materials. During the warranty period as mentioned below the new machine, all the parts
of the machine excluding the consumable components listed in the Limitations of Warranty
shall be replaced/ repaired free of charge on intimation to the company/ company
authorized service centrenearest to the place where the appliance is installed.
The warranty period will be 12/24/36/60(Twelve/Twenty-Four/Thirty Six/Sixty) months
from the date of invoice for all the above mentioned products respectively. Manufacturing
defects will be rectified free of cost during the said period. However normal applicable
repairing cum visiting charge would be applicable after one year. This warranty is subject
to Limitations of Warranty.
Limitations of the Warranty
The warranty becomes null and void in following cases:
If the warranty card is not fully and properly filled in and signed at the time of purchase/
installation by the company's authorized dealer/ service engineer. Copy of bill/ invoice is
mandatory to avail the warranty.
If the completed warranty card is not presented to the authorized IFB personnel at the timeof repair.
Installation / Service / Repairing or use of non-genuine / Modification carried out by
person other than those authorized by IFB.
Failure/damage due to user's negligence towards minor maintenance such as cleaning of
Filters/burners/Spark plug or not used in accordance with instructions given in the
instructions manual.
21
INSTALLATION
IFB GL-90 ISLAND-90CM
Reducer for
φ120 out-let
Air outlet
Low support frame
Screws
Blower box assembly
Upper duct cover
Low duct cover
Step 1:
Fix the position of the chimney in accordance
with the recommend-ed height between 650mm
to750mm from the hob and the lower edge of
the chimney.
Step 2:
Take out of the chimney from the carton box
and remove the filter , then put it on a
horizontal work table gently. Fix the reducer to
the airout let if needed . Otherwise fix the
exhaust pipe into the air outlet , make sure is
connected tightly.
Step 3:
Aiming the Low support frame to the holes on
the blower box assembly , fix it tightly.
Then pull out the exhaust pipe to the level of the
low support frame.
Step 4:
Insert the upper duct cover into the low
duct cover.
6
Advertisement
