Connecting Your Precision; Guidelines For Sky Reception - Maxview MXL012/55 Setup & User's Manual

CONNECTING YOUR PRECISION SYSTEM
ANSCHLUSS SCHEMA
A. Single LNB
B. Twin LNB - Only available on models MXL012/65TWIN, MXL012/55TWIN, MXL075TWIN
Twin-LNB – Nur bei den Modellen 40043 und 40045 vorhanden.
Note: A twin LNB system can also be connected to 2 receivers. Or 2 TV's with in-built sat tuners.
GUIDELINES FOR SKY™ SATELLITE RECEPTION
For SKY™ box users only: Outside of the UK, problems of reception and aligning the dish can start to
occur. The default frequency of the SKY™ 'Digi box' is set to a transponder on the North beam.
As you travel south and move out of the north footprint, you may need to change the default
transponder of the 'Digi box' to match the South beam.
To change the default transponder setting you will first need to access the hidden 'INSTALLER SETUP'
menu. Then press the 'SERVICES' button on your SKY™ remote and then '4' to access 'SYSTEM SETUP'.
Although it is not displayed, you will need to press '0' then '1' then 'SELECT' to access the 'INSTALLER
SET UP' menu, then '2' to enter 'DEFAULT TRANSPONDER'. The display will then show, from top to
bottom: Frequency, Polarisation, Symbol Rate, FEC and Save New Settings. Select 'FREQUENCY' and
by typing in the relevant numbers, change the settings from '11.778' to '12050'. Using the arrow keys,
change the settings to 27.5, 2/3, vertical (V). When the changes have been made you will then need to
'SAVE NEW SETTINGS'. Press 'BACK UP' to return to main screen. Note this information is subject to
change check our website for any possible updates.
SIGNAL STRENGTH METER ON SKY™ BOX
To align the dish to Astra 2 using the sky receiver, use the SIGNAL TEST menu built into the SKY™
digibox. To access this menu:
Press the SERVICES button on the remote control. Enter SYSTEM SETUP (number 4).
Enter SIGNAL TEST (number 6). The display will then show, from top to bottom:
SIGNAL STRENGTH - SIGNAL QUALITY- LOCK INDICATOR - NETWORK ID - TRANSPORT STREAM.
You will need to adjust the dish until there is at least a quarter of the SIGNAL QUALITY bar display,
the LOCK INDICATOR shows OK and the NETWORK ID is displaying 0002. If the NETWORK ID is
showing any other details, you have locked onto the wrong satellite and will need to re-align the dish.
Press BACK Up to exit menu's.
SKY is a registered Trademark
14
Main TV
Fernsehgerät
Scart or HDMI cable
Scart oder HDMI-Kabel
LNB 1
LNB 2
A
B
Satellite Receiver/Satelliten-Receiver
Power
Steckdose