Gewiss Chorus GW 10 862 User Manual page 36

Programming operations for the GW 20 481 control unit
PROGRAMMING THE GW 10/12/14 862 - GW 10/12/14 867 PUSH-BUTTON PANEL
FOR USE WITH THE GW 20 474 KEY
A = Remove the front plate
B = Place the 3 AAA batteries in the battery holder.
C = When using the GW 20 481 unit, access the REMOTE CONTROL menu to add a new
remote control device to the memorized list.
Nota: The capacity to memorize new command codes on the GW 20 481 unit correspond to:
D = When using the GW 10/12/14 862 – GW 10/12/14 867 push-button panel, press one
of the control buttons for 1", until the proximity key transponder area lights up.
E = Position the GW 20474 key on the transponder area.
F = When the control buttons flash, press one to enter the identification code.
G = Exit the programme settings on the GW 20 481 control unit by pressing STOP five times.
CHECKING THE SETTINGS FOR THE PUSH-BUTTON PANEL GW 10/12/14 862
GW 10/12/14 867
Using the GW 20 474 key:
H = Press one of the control buttons for 1", until the proximity key transponder lights up.
I = Position the GW 20 474 key on the transponder, the control buttons will start to
flash rapidly.
J = Press the control button relative to the preselected function mode on the control unit
and observe the consequent change in status.
USER INSTRUCTIONS
User codes to be entered using the
push-buttons on the keyboard
Proximity key codes
GW 20 472 remote controls
Total
+
+
=
16
36