Counter Mode - TTS Attention Tracker User Manual

Counter mode

Switch the Counter/Timer switch to the counter mode. The display will show
n
0000.
Select the rate for the counter (this is how often a point is added to the
n
display). Set the Count Rate switch to 10, 30 or 60 seconds as required.
Select the total time for the task. Set the Task time switch to 5, 10, or 20
n
minutes as required.
To start the counter, press the Start/Stop button. The unit will start counting
n
and the amber LED will be lit.
Every 10 seconds (30 seconds, or 60 seconds depending on Count Rate
n
switch) the display will increment by one count: 0001, 0002, 0003, etc.
The remote control can be used to add, or subtract points at any time. If
n
points (as set by the reward switch) are added the green light will flash
twice and if points are removed the red light will flash twice.
When the Task Time has ended, the Amber LED will switch off, and the Red
n
LED will switch on. The display will continue to count up and respond to the
remote control.