AMC K-LCD Installation Manual page 4

 Open the keypad housing pushing the flap in the lower part with a screwdriver by keeping the
keypad door open. (Fig. 1 Point 1)
 Take the posterior part of the keypad and fix it to the wall (the electronic board remains fixed to
the anterior part).
 During the fixation pay attention to the tearing element (Fig. 2 Point 1), if you want to have an
anti-tearing protection it is necessary to fix it to the wall with a screw, so as to keep the tamper
switch of the keypad closed. If you do not want to use the anti-tearing protection you have to
bend the switch flap, so as to keep it pressed when the housing is closed.
 Set the keypad address by using the dip-switches (refer to your Alarm Panel's Technical Manual)
 Connect the supply and data terminals to the bus terminals on the control unit board, do not
leave any copper debris on the circuit board. The wiring must be carried out only when the board
is unsupplied. Not respecting the correct installation guidelines will lead to malfunctioning or even
damage of the keypad
 Close the case by leaning the anterior part onto the clips of the posterior part. Then push the
anterior part of the housing until it clicks and fits together with the posterior part.
Fig. 1
Our products/systems comply with the essential requirements of EEC directives. Installation must be carried out following
the local installation norms by qualified personnel.
AMC Elettronica S.r.l. refuses any responsibility when changes or unauthorized repairs are made to the product/system. It is
recommended to test the operation of the alarm product/system at least once a month. Despite frequent testing and due to,
but not limited to, any or all of the following: tampering, electrical or communication disruption or improper use, it is
possible for the product/system to fail to prevent burglary, robbery, fire or otherwise. A properly installed and maintained
alarm system can only reduce the risk that this happens.
FIXATION AND CONNECTIONS
1
2
Fig. 2
1