Table of Contents
Advertisement
G-CODE TIMER RECORDING
PROGRAMMING
There are two ways of programming
G-Code
timer recordings,
One is using the on-screen display and the
other one is using the VCR display.
You can set up to 6 programmed
to be
recorded upon a period of up to 1 year.
On-screen
programming
Turn on the
TV, then set it to the preset
video channel or AV mode (if using the
"AV connection").
Press the G-CODE button.
Using the numeric buttons, enter the
Cod;
number for the programme you
want to record. (e.g. 489135)
~
;4L1913.5.i3.:.:.J
If you entered
a wrong number, press the
CLEAR button to delete it, then enter the
correct number.
Press the OK button.
'-l
G-CODE
NUMBER
489135 ---
PR
DATE
START
END
~01
25.12
15:00
16:OOW
Notes:
If the programme
position
number
(PR) displays
"--~j:
Enter the programme
position number the TV
station has been preset to.
That setting will be memorized and set the next
time the same TV station is selected.
m
+ +
25.12
15:00
16:OOW
Additional settings
Daily/Weekly
recording
Press the MENWTV button repeatedly to
select:
....
"f"-
~R DATE STARTfor daily recording (Monday
'Oi 25i'I"~F15'00 through Friday)
for weekly recording (the
.!; ~~;;wi~~~
same programme
every
week)
Changing
the end time
Each press of the CHANNEUTRACKING
(+
or –) button will change
the recording
end
time by units of 10 minutes.
Recording tape speed setting
Press the SP/LP button repeatedly to display
the desired tape speed.
Setting
the recording
type
Press the TYPE button repeatedly until the
desired type is displayed.
A
When allthesettings
areas
desired,
press the OK button.
You can programme
another
recording
by
repeating
steps 2 to 4.
~
Insert a video cassette with
erasure-prevention
tab.
Make sure the tape is longer than the total
recording time.
s
Press the G-CODE button.
The timer indicator (n) will light on the
VCR display and the VCR goes into
timer recording stand-by mode.
Note:
Even if a timer recording has been preset, the VCR
can be used as usual up to the programmed
start
time. When finished using the VCR, do not forget to
return it to timer recording stand-by mode.
ON-SCREENOPERATION
G-COOE
+77
:%
MENIJTV
J
SP/LP
CHANNEL/ -
TRACKING
TYPE
(+,-)
;
7
CLEAR
o-9
%.
OK
This VCR has a built-in G-Code
system. Programming timer
recordings is now as simple as
entering a Code number (1 to 9
digits) listed next to each
programme in your local TV
guide or newspaper TV
programme listing.
G-Code is a trademark applied for
by Gemstar Development Corp.
G-Code system is manufactured
under license from Gemstar
Development Corporation.
~
Newspaper orTV guide
I
I
—.-
.—
Easy process
1
Press the G-COOEbutton.
4
i 2
Enter the Code number.
I
I 3
Press the OK button.
I
Additional settings
4
' 4
Press the OK button.
4
I 5
Press the G-COOE button.
I
14
Advertisement
Table of Contents
