G-Code Timer Recording Programming; On-Screen Programming; On-Screen Operation - Sanyo VHR-830 Instruction Manual

ON-SCREEN OPERATION
o
c
G
s
~
This VCR has a built-in G-Code
system. Programming timer
recordings is now as simple as
entering a Code number (1 to 9
digits) listed next to each
programme in your local TV
guide or newspaper TV
programme listing.
I
G-CODE is a registered trademark
of Gemstar Development
Corporation.
The G-CODE s ystemis
manufactured underlicensefrom
Gemstar D evelopment
Corporation.
Newspaper o r TVguide
I
Code number
I
Easy process
~ 1 Pressthe G-CODE button.
~ 2 Enterthe Codenumber.
I
I 3 Pressthe OKbutton.
Additional settings
4
~ 4 Press the OKbutton.
~-preSstheG~ODEbutton.
15
G-CODE TIMER RECORDING
PROGRAMMING
There are two ways of programming G-Code
timer recordings.
One is using the on-screen display and the
other one is using the VCR display.
You can set up to 6 programmed to be
recorded upon a period of up to 1 year.
On-screen programming
1
2
Turn on the TV, then set it to the preset
video channel or AV
mode (if using the
"AV connection").
Press the G-CODE button.
Using the numeric buttons, enter the
Code number for the programme you
want to record. (e.g. 489135)
I
G=GODE..NUmER
;489~ .3.5.:.:.:.;
I
If you entered a wrong number,
press the
CLEAR button to delete it, then enter the
correct number.
3
Press the OK button.
G-CODE NUMBER
489135 ---
PR DATE START END
01 25.12 15:00 16:OOW
If the programme position number (PR)
displays "-–":
Enter the programme position number the TV
station has been preset to.
That setting will be memorized and set the
next time the same TV station is selected.
m
a When all thesettings are as desired,
press the OK button.
You can programme another recording by
repeating steps 2 to 4.
C9 Insert a video cassette with
5
erasure-prevention tab.
Make sure the tape is longer than the total
recording time.
Press the G-CODE button.
The timer indicator (B) will light on the
VCR display and the VCR goes into
timer recording stand-by mode.
Additional settings
After pressing the OK button in step 3.
Recording tape speed setting
Press the SP/LP button repeatedly to display
the desired tape speed.
JUST REC. mode setting
Press the SP/LP button until "A (Auto) is
display on-screen.
(See page 18 for information on JUST REC.)
Daily/Weekly recording
Press the MENUEW button repeatedly to
display the desired recording mode.
M-F: for daily recording (Monday through
Friday)
WK: for weekly recording (the same
programme every week)
Changing the end time
Each press of the CH (+ or -) button will
change the recording end time by units of 10
minutes.
Setting the recording type
Press the TYPE button repeatedly until the
desired type is displayed.
G-CODE NUMBER
489136 ---
PR DATE START HI%...
01 25,12 15:00 [---~-~-;
,1
FILM+ SPORT+ DRAMA+ MUSIC +
NEWS-+ANIMA+EDUC. +GAME+
THRIL+COMED